Use of cookies

This Gaggenau website uses cookies so you can place items in your shopping basket and allow Gaggenau to collect anonymous statistical data to help improve the performance of the website. Ignore this message or click accept if you are happy to continue. Click the links on the bottom of this page if you would like to view more information about the cookies that are used and how to manage your settings.

 

400 series Vario downdraft ventilation 400 series Stainless steel Width 11 cm

VL414111


Additional information

Output
  • Power levels depend on the remote fan unit, see table on page XX.
Features
  • Manual opening of the ventilation element.
  • Closing element made of stainless steel, dishwasher-safe.
  • Metal grease filter, dishwasher-safe.
  • No connecting piece included.
Consumption data
  • Consumption data is referred to a configuration with the remote fan unit AR 403 122.
  • Energy efficiency class A+ at a range of energy efficiency classes from A++ to E.
  • Energy consumption 42.7 kwh/year.
  • Ventilation efficiency class A.
  • Ilumination efficiency class -.
  • Grease filter efficiency class C.
  • Sound level min. 56 dB / max. 68 dB normal mode.
Planning notes
  • Refer to the table on page XX for the matching remote fan units for air recirculation or air extraction mode.
  • Secure the control unit to the side panel of the cabinet, not to the base of the cabinet or the kitchen floor.
  • For each VL one remote fan unit is recommended.
  • Maximum cooktop width between two VL: 60 cm.
  • Appliance can be snapped into the worktop from above. Additional fixing by clamps accessible from bottom up, clamping range 30-50 mm.
  • If installing with the appliance cover VA 440 or filler strip VA 450 take into account the additional space required for the depth.
  • If combining several appliances with at least one appliance cover, the filler strip VA 450 is required to compensate for the depth of the appliance without the appliance cover.
  • If combining several Vario appliances of the 400 series, a connection strip VA 420 must be placed between the appliances. Depending on the type of installation, the corresponding connection strip must be provided.
  • In the cut-out, the installation system requires the side edge to be at least 10 mm for surface mounting and at least 13 mm for flush mounting. Ensure a continuous cut surface of 90°.
  • The bearing capacity and stability, in the case of thin worktops in particular, must be supported using suitable substructures. Take into account the appliance weight and additional loads.
  • Additional instructions for flush mounting:
  • Installation is possible in worktops made of stone, synthetics or solid wood. Heat resistance and watertight sealing of the cut edges must be observed. Concerning other materials please consult the worktop manufacturer.
  • The groove must be continuous and even, so that uniform placing of the appliance on the gasket is ensured. Do not use discontinuous lining.
  • The joint width may vary due to size tolerances of the combinations and of the worktop cut-out.
  • If installing several appliances in individual cut-outs allow for a division bar of minimum 50 mm between the individual cut-outs.
  • If operated next to gas appliances, the ventilation moulding AA 414 010 is recommended to ensure maximum performance of the cooktop.
  • If installed next to gas appliances, flat ducts must not be used for the piping up to the fan unit.
  • If installed next to VP 414, the flat duct must not be positioned underneath the VP 414.
Connection
  • Connection cable 2.0 m between ventilation element VL 414 and control knob AA 490.

Downloads